Fender License LED Turn Signal Tail Light Bar Tag Light For Victory Vegas 03-17

Description

Description:
100% Brand new&Hight Quality!!
The mounts directly into place under the fender for a perfect fit
Strong ABS plastic construction of Lighting mounting bracket
Aluminum Licence Bracket
Give your Victory Vegas a clean, custom look with this new rear fender eliminator kit with
tag mount.
plate holder and lolli-pop style turn signals for a sleek,
Provides an additional safety benefit with its wraparound design
custom look for your Victory Vegas.
Kit includes an under the fender low profile license plate mount
You will require a load equalizer to maintain stock flash rate if both front and rear turn
signals are replaced with LEDs.
Fitment:
For 03-17 Victory Vegas
For 06-17 Vegas 8-Ball
For 12-17 High Ball
For 15-17 Gunner
PS.Fits all standard US 4"x7" License Plates
Installation
**Attention** For your safety,disconnect battery ground before installation of this product
Step1)
Test LED light to Battery before installation.Test the LED light by touching wires directly to bike battery.Black is ground and colored wires are positive.
Step2)
Remove seat and rear fender and place upside down on a clean soft surface to protect painted surface(refer to Vegas Maintenance Manual for proper rear fender removal procedure).Remove the stock inner fender with the tag mount and stock turn signals.Save the two nut from the mounting post(see Pic#1).You will need these for re-assembly.
Step3)
Assembly.Your new fender kit comes pre-assembled however the adjustment bolts and nuts are not tight.Place new fender kit over mounting post and with two large washers(from the kit)and 2 stock nuts removed in Step2(see Pic#1&Pic#2).Align light bar with fender edge and tighten nuts.Route wires alongside the stock taillight wires and secure with zip ties.Be sure to leave adequate slack and avoid pinch points.